Install Lens(Es); Primary Zoom Lens Installation; Install First Lamp - Christie CP2000 Setup Manual

Section 2: Installation and Setup

2.1.4 INSTALL LENS(ES)

PRIMARY ZOOM LENS INSTALLATION

1. Orient your high-contrast lens with its notches at the top,
then fully insert the assembly straight into the lens mount
opening all the way back without turning. With the lens
fully back, it will seat properly within the lens mount and
the aperture will be oriented correctly.
NOTE: High Contrast lenses (only) have a flat on the rear
flange. Rotate the lens so that the flange clears two screws in the
mount. Also ensure the UP label is at the top to ensure proper
aperture orientation.
2. Lock the lens assembly in place with the lens clamp
DOWN.
NOTE: The lens seals the projector head, preventing
contaminants from entering the main electronics area. Never
attempt to operate the projector without a lens installed.
ANAMORPHIC LENS INSTALLATION
NOTE: Required only for 1.25x anamorphic lens, producing 2.39:1"scope" images.
If the anamorphic lens will be used, it is recommended that you now add the lens—and its motorized
mount—so that the additional weight will be present when correcting later for final leveling, boresight
and the like. Install only for those installations requiring full-size 2.39:1 "scope" images (mostly side-
masking screens).
1.
INSTALL THE ANAMORPHIC LENS MOUNT ON THE PROJECTOR:
install the motorized anamorphic lens mount hardware as described in the instructions provided
with the anamorphic lens mount kit.
2.
INSTALL THE 1:25x ANAMORPHIC LENS:
following the instructions provided with the anamorphic lens mount kit.

2.1.5 INSTALL FIRST LAMP

Install one of the following lamps in the projection head, depending on your model and site:
* For this projector, the 2.0 kW is available in CDXL (maximum performance) only
** Available as CDXL (maximum performance) or original CXL (less expensive).
Refer to full specifications in Section 8 of User MAnual
2-12
(OPTIONAL)
Clamp the 1.25x anamorphic lens mount in place,
Table 2.2 Lap Models
CP2000i Lamps
2.0 kW* 2.0 kW**
3.0 kW** 3.0 kW **
4.5 kW**
6.0 kW**
At the front of the projector,
CP2000h/-S Lamps
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)