Adjust Left/Right Boresight - Christie CP2000 Setup Manual

Section 2: Installation and Setup
NOTES: 1) Horizontal offset is just a few dozen pixels, resulting in a maximum of 52% of the image
displayed on one side or the other of the lens. 2) Maximum offsets are slightly less when offsetting in
both directions (H an V) at once.

ADJUST LEFT/RIGHT BORESIGHT

1. Adjust focus at the far left center
edge of the image (Figure 2-38). If
possible, reduce image size for
easier image analysis.
2. If the image appears well-focused
on the left edge, but not on the
right, then the boresight currently
differs from one side to the other
(i.e., the right side of the image is
well-focused either in front of or
behind the screen surface rather
than on it).
2-26
F 2-37 V O
IGURE ERTICAL
F
IGURE
R
FFSET ANGE
2-38 A F
DJUST OCUS AT
L E
EFT DGE
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)