FRU Disassembly
Fuser Assembly
8-44
Note
The fuser used in the Phaser 4510 is different than the fuser used in the
Phaser 4500. The fusers are NOT interchangeable.
(PL8.1.20)
3
1. Right fuser lever
2. Left fuser lever
Procedure:
Warning
The fuser assembly is very hot immediately after the printer is turned off.
To avoid possible burns, wait to remove the fuser until it cools down
sufficiently to be handled.
1.
Open the paper exit rear door (page 8-5).
2.
Push down the left and right fuser levers in the direction of the arrow to
release the fuser assembly locks.
3.
Pull the fuser assembly out the back of the printer as indicated by the
arrow.
1
3. Fuser assembly
2
s4500-119
Phaser 4500/4510 Service Manual