Tray 3 Failure/Tray 3 Or 4 Failure - Xerox Phaser 4500 Service Manual

Error Messages and Codes

Tray 3 Failure/Tray 3 or 4 Failure

3-54
No recognition of the optional 550-sheet feeder.
Diagnostic Error Codes
E11-1: Tray 3 failure
E11-2: Tray 3 or 4 failure
Troubleshooting Reference
Applicable Parts
LVPS
HVPS/engine logic board
550-sheet feeder PWBA
Feeder harness 2
Feeder harness 5
Note
This procedure assumes that optional 550-sheet paper feeders are
installed as tray 3 and tray 4.
Troubleshooting Procedure
Steps Actions and Questions
Check feeder harness 2 of the tray 3
1
feeder:
1. Remove the optional 150-sheet
paper feeder.
2. Disconnect P/J2083.
3. Check the following for continuity:
J2083-1 <=> J83-10
J2083-2 <=> J83-9
J2083-3 <=> J83-8
J2083-4 <=> J83-7
J2083-5 <=> J83-6
Is each continuous?
Wiring and Plug/Jack Map References
"550-Sheet Feeder General Wiring Diagram" on
page 10-32
"550-Sheet Feeder Signal Diagram" on
page 10-33
"550-Sheet Feeder Plug/Jack Locator" on
page 10-12
Yes
Go to "Optional
550-Sheet
Feeder PWBA
(Tray 3)" on
page 4-39, or
go to step 2 if
Tray 4 is not
recognized.
Phaser 4500/4510 Service Manual
No
Replace feeder
harness 2.