Feed Clutch, Registration Clutch - Xerox Phaser 4500 Service Manual

Feed Clutch, Registration Clutch

Phaser 4500/4510 Service Manual
4. Release the hook of the nudger roller, and pull the nudger roller out from
the nudger shaft.
5. Release the hook of the nudger gear, and pull the nudger gear out from
the nudger shaft.
Replacement Note:
After the no paper actuator is replaced, manually operate it to verify that it
moves smoothly, and that the no paper actuator (4) is positioned as
shown in the illustration.
(PL5.1.21) (PL5.1.23)
P/J242
1. Feed clutch
Procedure:
1. Remove the 150-sheet feeder assembly (page 8-15).
2. P4500 only: Disconnect the connector (P/J 242) of the feed clutch from
the tray 1 harness assembly.
3. Remove the E-ring retaining the feed clutch, and slide the feed clutch
assembly from the feed shaft.
4. P4500 only: Disconnect the connector (P/J 243) of the registration clutch
from the tray 1 harness assembly.
5. Remove the E-ring retaining the registration clutch, and slide the
registration clutch from the metal registration roller.
P/J243
2. Registration clutch
FRU Disassembly
1
2
s4500-096
8-19