Jam At Tray N - Xerox Phaser 4500 Service Manual

Jam at Tray N

Phaser 4500/4510 Service Manual
Paper arrives late at the registration sensor.
Diagnostic Error Codes
E2-11: Feed Jam 2 at Tray 1
E2-12: Feed Jam 2 at Tray 2
E2-13: Feed Jam 2 at Tray 3
E2-14: Feed Jam 2 at Tray 4
Troubleshooting Reference
Applicable Parts
150-sheet feeder assembly
150-sheet paper cassette
Registration sensor
Registration actuator
Feeder 1 chute assembly
HVPS/engine logic board
LVPS
Feeder 2 chute assembly
Feed clutch assembly
Retard roller
Turn roller clutch
Optional 550-sheet feeder
550-sheet feeder assembly
550-sheet paper cassette
Troubleshooting Procedure
Steps Actions and Questions
1 Check the paper size setup.
Does the paper size in use match the
size set up by the end guide
assembly or by the driver on the PC?
Does the error occur when the power
2
is turned ON?
3 Check the condition of the paper in the
tray.
Is the paper crumpled, damaged,
damp, or out of specification?
4 Check the paper at the registration
sensor.
Does the paper remain at the
registration sensor?
Error Messages and Codes
Wiring and Plug/Jack Map References
"150-Sheet Feeder, 550-Sheet Feeder, Main
Fan" on page 10-27
"P4500: 24 V Interlock, Rear Cover Switch,
Main Motor, Sub Fan, Exit Motor Assembly" on
page 10-21
"Print Engine Wiring Diagrams" on page 10-19
"Print Engine Plug/Jack Locator" on page 10-3
Yes
Go to step 2.
Go to step 3.
Replace the
paper.
Remove the
paper, and go to
step 5.
No
Replace the
paper, or
change the
paper size
setup.
Go to step 6.
Go to step 4.
Go to
"Registration
Sensor" on
page 4-17.
3-37