No Paper In Tray 3/No Paper In Tray 4 - Xerox Phaser 4500 Service Manual

No Paper in Tray 3/No Paper in Tray 4

Phaser 4500/4510 Service Manual
Error Indications
No Paper in Tray 3
No Paper in Tray 4
Troubleshooting Reference
Applicable Parts
HVPS/engine logic board
LVPS
No paper sensor
No paper actuator
Optional 150-sheet paper
feeder
550-sheet paper cassette
Troubleshooting Procedure
Steps Actions and Questions
Is there any paper in tray 3 or tray 4?
1
2 Is the bottom plate assembly
(PL20.3.10) lifted correctly?
3 1. Remove the paper cassette.
2. Manually operate the no paper
actuator.
Does the no paper actuator move
smoothly?
Check the no paper sensor:
4
1. Remove the print cartridge.
2. Enter Service Diagnostics, and from
the
tray 3 or tray 4
3. Manually operate the no paper
actuator.
Does the sensor correctly report the
position of the sensor actuator?
Wiring and Plug/Jack Map References
"550-Sheet Feeder General Wiring Diagram" on
page 10-32
"550-Sheet Feeder Signal Diagram" on
page 10-33
"550-Sheet Feeder Plug/Jack Locator" on
page 10-12
Sensor Tests menu select the
No Paper test.
Error Messages and Codes
Yes No
Go to step 2. Add paper.
Go to step 3. Remove the
550-Sheet
paper cassette,
then re-install it
correctly.
Go to step 4. Replace the no
paper actuator.
Replace the Go to "Optional
HVPS/engine 550-Sheet
logic board Feeder No
(page 8-73). Paper Sensor"
on page 4-41.
3-65