Image Processor (I/P) Board - Xerox Phaser 4500 Service Manual

Image Processor (I/P) Board

Phaser 4500/4510 Service Manual
(PL 12.1.13)
P4500
J110
2
4
J800
1. Memory DIMMs
2. Flash memory (optional)
3. Hard disk drive (optional)
Procedure:
Caution
Observe electrostatic precautions when handling the I/P board and its
components.
Do not attempt to slide the I/P board out from the rear of the printer due to
the potential for damage to the capacitors along the bottom of the board.
1. Remove the right cover (page 8-7).
2. Remove the image processor shield assembly (page 8-70).
3. Unplug the ribbon cable from J800 (the connector to the HVPS/engine
logic board). Be sure to note the orientation of the blue stripe on the
ribbon.
J130
FRU Disassembly
5
1
3
s4500-255
4. NVRAM (U660)
5. Rear panel
8-75