Xerox Phaser 4500 Service Manual page 290

FRU Disassembly
8-10
5. Open the top cover and slide the link lever off the boss (item 1 in the
figure).
6. Remove the top cover assembly.
a. Lift the rear of the top cover assembly and slide the cover forward
enough to release the hooks at the front.
b. Tilt up the front and disconnect the control panel harness from the
connector (P4500: P/J810; P4510: J230) on the control panel circuit
board.
c. Release the control panel harness from the cable restraint.
7. Push the end tab of the control panel to release it, and slide the control
panel out through the top.
Replacement Notes:
When sliding the link lever onto the boss of the top cover, the top cover
should be opened, and the link lever should be extended upward.
When installing the paper exit assembly, feed the harnesses of the exit
motor assembly and exit sensor harness assembly into the larger
openings in the frame.
Phaser 4500/4510 Service Manual