Jam At Tray N - Xerox Phaser 4500 Service Manual

Error Messages and Codes

Jam At Tray N

3-34
Paper arrives early at the registration sensor
Diagnostic Error Codes
E2-01: Feed Jam 1 at Tray 1
E2-02: Feed Jam 1 at Tray 2
E2-03: Feed Jam 1 at Tray 3
E2-04: Feed Jam 1 at Tray 4
Troubleshooting Reference
Applicable Parts
150-sheet feeder assembly
150-sheet paper cassette
Registration sensor
Registration actuator
(Actuator B)
LVPS
HVPS/engine logic board
Registration clutch
Feeder 1 chute assembly
Gear assembly housing
No paper sensor
Feeder 2 chute assembly
Bottom plate assembly
Retard roller
Feed clutch assembly
Turn roller
Turn roller clutch
550-sheet feeder assembly
550-sheet paper cassette
Troubleshooting Procedure
Steps Actions and Questions
Remove all jammed paper from the
1
tray?
Does the error still occur?
Check the condition of the paper in the
2
tray.
Is the paper crumpled, damaged,
damp, or out of specification?
Compare the size of the paper in use
3
with the tray's End Guide settings and
the paper size selected by the print
driver.
Does the paper size in use match the
settings?
Wiring and Plug/Jack Map References
"150-Sheet Feeder, 550-Sheet Feeder, Main
Fan" on page 10-27
"P4500: 24 V Interlock, Rear Cover Switch,
Main Motor, Sub Fan, Exit Motor Assembly" on
page 10-21
"Print Engine Wiring Diagrams" on page 10-19
"Print Engine Plug/Jack Locator" on page 10-3
Yes
Go to step 2.
Replace the
paper.
Go to step 4.
Phaser 4500/4510 Service Manual
No
Go to "No Paper
in Tray 1/No
Paper in Tray 2"
on page 3-63.
Go to step 3.
Replace the
paper, or set up
the paper size
correctly.