Paper Tray Empty With No Indication - Xerox Phaser 3140 Service Manual

Paper Tray Empty With No Indication

Phaser 3140/3155/3160 Printer Service Manual
Troubleshooting Procedure Table (Continued)
Step Actions and Questions
3 Replace the Power Supply Board.
Does the problem persist?
The Status LED does not indicate when the Tray is empty.
Initial Actions
• Check the paper path for obstructions or debris.
• Cycle printer power.
• If the problem persists, refer to the following procedure.
Troubleshooting Reference Table
Applicable Parts
Paper Tray Empty Actuator,
PL6.0.56
Power Supply Board, PL1.0.1
Controller Board, PL1.0.2
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the Paper Tray Empty
Actuator for damage.
Is the actuator damaged?
2 Check the continuity of the harness
connecting the Power Supply Board
CON2 and the Controller Board CN5
(CN7 on the 3160).
Is the harness damaged?
3
Replace the Power Supply Board
(page 8-54).
Does the problem persist?
4
Replace the Controller Board
(page 8-51).
Error Messages and Codes
Yes
Replace the
Controller
Board
(page 8-51).
Wiring and Plug/Jack Map References
3140 Power Supply Wiring
3155 Power Supply Wiring
3160 Power Supply Wiring
Map 4 - 110V and 220V Power Supply
Boards
Yes
Repair or
replace the
actuator
(page 8-47).
Repair the
harness.
If the problem
persists, go to
step 3.
Go to step 4.
Complete.
No
Complete.
No
Go to step 2.
Go to step 3.
Complete.
3-15