Bridge Commands
bridge ifconfig
Configure a bridge interface.
SYNTAX:
bridge ifconfig
where:
intf
The name of the bridge interface to configure.
dest
The destination for this interface. Typically a phonebook entry.
This parameter only needs to be specified when an interface has been created
without specified destination.
qos
The name of the Quality Of Service (QoS) book entry to apply on this bridge interface.
encaps
The type of encapsulation to be used for this bridge interface.
Choose between:
fcs
Whether or not to include the Ethernet FCS in the packet header on the WAN side.
Choose between:
The default is off.
Note
portstate
The bridge portstate for this interface.
Choose between:
The default is forwarding.
retry
A number between 0 and 65535.
Represents the number of times the SpeedTouch
connection before giving up.
The default is 10.
50
intf = <intfname>
[dest = <string>]
[qos = <string>]
[encaps = <{llc/snap | vcmux}>]
[fcs = <{off | on}>]
[portstate = <{disabled | learning | forwarding}>]
[retry = <number {0-65535}>]
llc/snap
vcmux.
off
on.
FCS is normally left off.
disabled
learning
forwarding.
TM
retries to set up a WAN
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040907-0010 v1.0