Systemlog Send - THOMSON 516 Reference Manual

Systemlog Commands

systemlog send

Send syslog messages from the internal SpeedTouch
syslog server host.
There will be no notification on whether the host has received the messages or not.
SYNTAX:
systemlog send
where:
fac Specify the facility name of the syslog messages to be shown.
Use one of the supported facility names (see
Note
sev Specify the lowest priority severity of the syslog messages to be shown.
Only the messages with a severity as specified or higher will be shown.
Use one of the supported severity names (see
page 380).
Note
hist Show messages over several SpeedTouch
latest startup (no).
Note
dest The IP address of the remote host on the local or remote network, i.e. the collector's IP
address, to send the syslog messages to.
356
[fac = <supported facility name>]
[sev = <supported severity name>]
[hist = <{no | yes}>]
dest = <ip-address>
If not specified, the messages of all the facilities will be shown.
If not specified, the messages of all the facilities will be shown.
If not specified, only the recent messages will be shown.
TM
Syslog message buffer to a specified local or remote
" Supported Syslog Facilities" on page
" Supported Syslog Severities" on
TM
reboots (yes) or show only messages since
OPTIONAL
379).
OPTIONAL
OPTIONAL
REQUIRED
E-DOC-CTC-20040907-0010 v1.0