pptp ifadd
Add a Point-to-Point Tunneling Protocol (PPTP) profile.
For backwards compatibility with previous release, use profibles instead.
SYNTAX:
pptp ifadd
dest = <string>
[rate = <number{10-10000}>]
[encaps = <{vcmux | nlpid}>]
[ac = <{never | always | keep}>]
where:
dest
The WAN destination for this PPTP tunnel.
Typically a phonebook entry.
rate
A number between 10 and 10000.
Represents the transmission speed in bits/s for the WAN link.
encaps
The type of WAN encapsulation.
Choose between:
vcmux
nlpid (Network Layer Protocol IDentifiers (NLPID)).
The default is vcmux.
ac
The High-level Data Link Control (HDLC) framing option applicable to PPTP interfaces
using this PPTP profile.
Choose between:
always: Before relaying the encapsulated PPP frames over the PPPoA link, make
sure that the address and control field (0xFF03) is always in front of the frames.
never: Before relaying the encapsulated PPP frames over the PPPoA link, make
sure the address and control field will never be found in front of the frames.
keep: Do not change the frames arriving via the PPTP tunnel.
The default is
never
Note
It is recommended to keep this setting.
EXAMPLE:
=>pptp list
Dialstr
Destination
DIALUP_PPP3
=>
E-DOC-CTC-20040907-0010 v1.0
(compliant to RFC2364).
QoS
Encaps
AC
default
vcmux
never
State
User
CONNECTED
(10.0.0.2)
PPTP Commands
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
307