Pppoa Rtadd - THOMSON 516 Reference Manual

PPPoA Commands

pppoa rtadd

Automatically add a route configuration to the routing table.
The route will be added when the specified PPPoA interface link comes up. This route configuration will determine
which local hosts are allowed to use this link and/or which remote destinations should be or should not be
reachable.
SYNTAX:
pppoa rtadd
where:
intf The name of the PPPoA interface.
dst The destination IP address for the route to be added when the link comes up.
dstmsk The destination IP mask.
Depending on the destination netmask:
Any remote destination is reachable, i.e. the PPPoA connection acts as default
route (
Only the remote (sub)net is reachable (
will be the default netmask applicable for destination IP address
Only the single remote host is reachable (
netmask in case of Variable Length Subnet Masking (VLSM).
label The name of the label.
src The source IP address specification (in other words, who can use this link).
srcmsk The source IP mask.
Depending on the source netmask:
Everybody is allowed to use this PPPoA connection (
Only members of the same subnet as the host which opened the PPPoA
connection are allowed to use the PPPoA connection (
destination mask will be the netmask applicable for the IP address of the host
which opened the PPPoA connection.
Only the host which opened the PPPoA connection is allowed to use the PPPoA
connection (
metric A number between 0 and 100.
Represents the route metric (the cost factor) of the route.
Practically, the cost is determined by the hop count.
282
intf = <intfname>
dst = <ip-address>
[dstmsk = <ip-mask(dotted or cidr)>]
[label = <string>]
[src = <ip-address>]
[srcmsk = <ip-mask(dotted or cidr)>]
[metric = <number{0-100}>]
dstmsk=0 )
srcmsk=32
). Any valid (contiguous) netmask in case of VLSM.
dstmsk=1 ). The actual destination mask
dstmsk=32
). Any valid (contiguous)
srcmsk=0 )
srcmsk=1
). The actual
REQUIRED
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040907-0010 v1.0