Eth Ifconfig - THOMSON 516 Reference Manual

eth ifconfig

Configure the Ethernet port.
SYNTAX:
eth ifconfig intf = <number>
type = <{auto | 10BaseTHD | 10BaseTFD | 100BaseTHD | 100BaseTFD}
where:
intf The number of the Ethernet interface to be configured.
type The Ethernet type.
Select either:
auto: Auto negotiation of Ethernet communication speed (10Mb/s or 100Mb/s) and
Duplex mode (half duplex or full duplex).
10BaseTHD: 10Mb/s communication speed in half duplex mode.
10BaseTFD: 10Mb/s communication speed in full duplex mode.
100BaseTHD: 100Mb/s communication speed in half duplex mode.
100BaseTFD: 100Mb/s communication speed in full duplex mode.
or enter a number between 0 (auto) and 5 (100BaseTFD).
The default is auto.
Note
This value should never be changed, except in case of communication
problems.
RELATED COMMANDS:
eth iflist
E-DOC-CTC-20040907-0010 v1.0
or number>
Show the Ethernet port configuration and current operating status.
Eth Commands
REQUIRED
REQUIRED
143