dhcp server config
Show/set the DHCP server configuration settings.
SYNTAX:
dhcp server config
where:
autodhcp
Allow the SpeedTouch
time and probe for another DHCP server on the network for some time before
starting its own DHCP server (on) or immediately start the DHCP server (off).
The default is on.
scantime
A number between 0 and 1814400 (seconds).
Represents the time for which the SpeedTouch
be active in the network.
The default is 20.
state
State of the DHCP server (enabled/disabled).
The default is enabled.
trace
Disable (off) or enable (on) verbose console logging and generation of debug traces.
The default is off.
EXAMPLE:
=>dhcp server config
autodhcp: on
scantime: 20s
state: disabled
tracing: off
=>dhcp server config scantime=30 tracing=on
=>dhcp server config
autodhcp: on
scantime:30s
state: disabled
tracing: on
=>
E-DOC-CTC-20040907-0010 v1.0
[autodhcp = <{off | on}>]
[scantime = <number>]
[state = <{disabled | enabled}>]
[trace = <{off | on}>]
TM
to present itself as DHCP client (AutoDHCP mode) at boot
TM
scans for another DHCP server to
DHCP Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
99