THOMSON 516 Reference Manual page 278

PPPoA Commands
pcomp
accomp
trace
auth
restart
retryinterval
passive
silent
echo
mru
laddr
raddr
276
Try (on) or do not try (off) to negotiate PPPoA protocol compression (LCP
PCOMP).
The default is off.
Try (on), do never try (off) or negotiate (negotiate) to negotiate PPPoA address &
control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated, i.e. the
address field FF-03 should not be sent over ATM.
The default is on.
If the accomp parameter is set to 'negotiate', the local side of the PPPoA
connection demands to do ACCOMP and adapts itself to the result of this
negotiation.
Enable (on) or disable (off) verbose console logging.
The default is off.
Select the authentication protocol.
Choose between:
pap: Password Authentication Protocol (PAP) authentication will be forced
chap: Challenge Handshake Authentication Protocol (CHAP) authentication
will be forced
auto: CHAP authentication will be used. If CHAP authentication is not
successful, PAP authentication will be used instead.
The default is auto.
Automatically restart the connection when Link Control Protocol (LCP) link goes
down (on) or do not restart automatically (off).
The default is on.
A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish the
connection on ATM level.
The default is 10.
Put the link in listening state in case LCP times out (on) or not (off).
This parameter allows to determine whether the link should be left open to wait
for incoming messages from the remote side after 10 unsuccessful tries to
establish the connection or not.
The default is off.
Do not send anything at startup and just listen for incoming LCP messages (on) or
retry up to 10 times to establish the connection (off).
The default is off.
Send LCP echo requests at regular intervals (on) or not (off).
The default is on.
A number between 293 and 8192.
Represents the maximum packet size the SpeedTouch
able to receive.
The default is 1500.
The local IP address of the peer-to-peer connection.
Specifying a local IP address forces the remote side of the PPPoA link (if it allows
to) to accept this IP address as the SpeedTouch
If not specified, the SpeedTouch
Typically, the local IP address parameter is not specified.
The remote IP address of the peer-to-peer connection.
Specifying a remote IP address forces the remote side of the PPPoA link (if it
allows to) to accept this IP address as its PPPoA session IP address.
If not specified, the SpeedTouch
Typically, the remote IP address parameter is not specified.
TM
should negotiate to be
TM
PPPoA session IP address.
TM
will accept any IP address.
TM
will accept any IP address.
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040907-0010 v1.0