Eth Bridge Vlan Ifconfig - THOMSON R7.4 Configuration Manual

Modifying VLAN membership
To modify the configuration of a bridge port that is member of a VLAN, execute the command

:eth bridge vlan ifconfig

Three parameters must be specified:
Name: the name of the VLAN.
Intf: the name of the bridge port.
Untagged: this parameter indicates whether the bridge port is tagged or untagged member of that VLAN.
If the parameter is enabled, the bridge port is untagged member of the VLAN.
If the parameter is disabled, the bridge port is tagged member of the VLAN.
=>:eth bridge vlan iflist
Vid Name
--- ----
1 default
2 data
=>:eth bridge vlan ifconfig name=data intf=ethport1 untagged=disabled
=>:eth bridge vlan iflist
Vid Name
--- ----
1 default
2 data
The only parameter that can be modified with this command is the parameter untagged. The
specified bridge port must already be member of the specified VLAN.
E-DOC-CTC-20080229-0001 v1.0
4|
.
Bridge interfaces (* = untagged)
--------------------------------
OBC*, ethport1*, ethport2*, ethport3*, ethport4*, WLAN*
OBC, ethport1*
Bridge interfaces (* = untagged)
--------------------------------
OBC*, ethport1*, ethport2*, ethport3*, ethport4*, WLAN*
OBC, ethport1
Ethernet Bridge and VLANs
19