Upnp Config - THOMSON 516 Reference Manual

UPnP Commands

upnp config

Configure UPnP parameter(s).
SYNTAX:
upnp config
where:
maxage
defcservice
writemode
safenat
preferredaddress
EXAMPLE:
=>upnp config
ssdp max-age
default connection service :
write mode
safe nat entries
preferred address
multicast interface(s)
=>
360
[maxage = <number{60-999999}>]
[defcservice = <string>]
[writemode = <{full | natonly | readonly}>]
[safenat = <{disabled | enabled}>]
[preferredaddress = <ip-address>]
This parameter allows to configure how often the SpeedTouch
notification message to advertise its presence as an Internet Gateway Device
(IGD) on the network.
Setting this parameter to a low value will increase the number of packets sent
over time on the network, but will make the state of the device more up to
date.
The default is 1800.
This parameter allows to configure the connection service to be used by the
TM
DrSpeedTouch application during the troubleshooting process (only when
several connection services are configured on the SpeedTouch
the default connection service).
Choose the set of rules to limit remote access from UPnP.
Choose between:
full: the host will accept all the UPnP SET and GET actions.
natonly: GET and NAT related SET actions will be accepted, all other
actions will be ignored.
readonly: the UPnP control point will only be able to retrieve
information, all the SET actions are ignored.
The default is full.
Enable or disable check on safe NAT entries.
If this check is enabled, all NAT create/delete requests for a LAN side IP
address different from the source IP address of the UPnP message will be
discarded.
The default is disable.
Preferred IPaddress for UPnP advertisements (enter 0.0.0.0 for none).
: 1800
: full
: disabled
:
: eth0 (10.0.0.138)
TM
sends a OPTIONAL
OPTIONAL
TM
, else only
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040907-0010 v1.0