Nat Config - THOMSON 516 Reference Manual

NAT Commands

nat config

Configure NAT parameters for IP session.
SYNTAX:
nat config
where:
timeout_ICMP
timeout_UDP
timeout_TCP
timeout_TCP_nego
timeout_other
ike_port
EXAMPLE:
=>nat config
Timeout ICMP idle
Timeout UDP idle
Timeout TCP idle
Timeout TCP negotiation idle :
Timeout Other idle
IKE outside port number
=>
252
[timeout_ICMP = <string>]
[timeout_UDP = <string>]
[timeout_TCP = <string>]
[timeout_TCP_nego = <string>]
[timeout_other = <string>]
[ike_port = <{fixed | floated}>]
The interval of time for which an ICMP protocol session is allowed to
remain valid without any activity.
Syntax: <HH:MM> or <MM>.
The interval of time for which an UDP protocol session is allowed to remain
valid without any activity.
Syntax: <HH:MM> or <MM>.
The interval of time for which an TCP protocol session is allowed to remain
valid without any activity. This timeout value applies to a TCP session
during its data transfer phase.
Syntax: <HH:MM> or <MM>.
The interval of time for which an TCP protocol session is allowed to remain
valid without any activity. This timeout value applies to a TCP session
during its establishment and termination phases.
Syntax :<HH:MM> or <MM>.
The interval of time for which an IP session for a protocol other than ICMP,
UDP and TCP is allowed to remain valid without any activity.
Syntax: <HH:MM> or <MM>.
The IKE outside port number. This is the translation port number for IKEv1
(fixed to 500 or floated).
: 00h01m
: 00h05m
: 00h15m
00h02m
: 00h01m
: Floated
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040907-0010 v1.0