THOMSON 516 Reference Manual page 175

IP Commands
Introduction
This chapter describes the commands of the ip command group.
Contents
This chapter covers the following commands:
ip apadd Assign an IP address to an IP interface.
ip apdelete Remove an IP address from an IP interface.
ip aplist Show a list of all configured IP addresses.
ip arpadd Add an entry to the ARP cache of a broadcast IP interface.
ip arpdelete Remove an entry from the ARP cache.
ip arplist Show the ARP cache.
ip config Show/set global IP stack configuration options.
ip flush Flush the complete IP configuration.
ip ifconfig Configure IP interface parameters.
ip iflist Show all IP interfaces.
ip ifwait Wait for a status change of an IP interface.
ip mcadd Add an MC address to an MC capable interface.
ip mcdelete Delete an MC address to an MC capable interface.
ip mclist List all MC addresses.
ip ping Send ICMP ECHO_REQUEST packets.
ip rtadd Add a route to the SpeedTouchTM routing table.
ip rtdelete Delete a route from the routing table.
ip rtlist Show the current routing table.
ip sendto Send UDP packets.
ip traceroute Send ICMP/UDP packets to trace the ip path.
ip auto flush Flush the autoIP interfaces.
ip auto ifadd Create a new autoIP interface.
ip auto ifattach Select and assign a link-local address to an autoIP interface.
ip auto ifconfig Configure an autoIP interface.
ip auto ifdelete Delete an existing autoIP interface.
ip auto ifdetach Release the link-local address for the given autoIP interface.
ip auto iflist Show the autoIP interfaces.
E-DOC-CTC-20040907-0010 v1.0
IP Commands
174
176
177
178
179
180
181
184
185
186
187
188
189
190
191
192
193
194
195
196
198
199
200
201
202
203
204
173