Table of Contents
Advertisement
4.7.3 Motion detect record/snapshot
Motion detect record
4.7.3.1
a)
From Main menu->Setting->Event->Detect, you can go to the following interface. See
Figure 4-51.
b)
Select motion detect from the event type dropdown list. Select a channel from the
dropdown list and then check the enable button to enable motion detect function.
c)
Click Region Select button to set motion detect zone. There are 396(PAL)/330(NTSC)
small zones. The green zone is current cursor position. Grey zone is the motion
detection zone. Black zone is the disarmed zone. You can click Fn button to switch
between the arm mode and disarm mode. In arm mode, you can click the direction
buttons to move the green rectangle to set the motion detection zone. After you
completed the setup, please click ENTER button to exit current setup. Do remember to
click the save button to save current setup. If you click ESC button to exit the region
setup interface system will not save your zone setup.
d)
Period: Click set button, you can see an interface is shown in Figure 4-74. Here you can
set the motion detect period. System only enables motion detect operation in the
specified periods. This is not for video loss or the tampering. There are two ways for you
to set periods. Please note system only supports 6 periods in one day.
In Figure 4-74, Select icon
Now the icon is shown
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-51
of several dates, all checked items can be edited together.
. Click
to delete a record type from one period.
57
Advertisement
Table of Contents
