Information; Version - Qvis IZEUS 7000 NVR RANGE User Manual

Please refer to the following sheet for detailed information:
Parameter Function
Select speed dome connected channel.
Channel
There are two options: local/remote.
PTZ Type
Please select remote type if you are connecting to the network PTZ.
Select the corresponding dome protocol such as PELCOD.
Protocol
Set corresponding dome address. Default value is 1. Please note
Address
your setup here shall comply with your dome address; otherwise
you cannot control the speed dome.
Select the dome baud rate. Default setup is 9600.
Baud
Rate
Data Bit Default setup is 8. Please set according to the speed dome dial switch
setup.
Default setup is 1. Please set according to the speed dome dial switch
Stop bit
setup.
Parity Default setup is none. Please set according to the speed dome dial
switch setup.

Information

5.9

5.9.1 Version

The version interface is shown as in Figure 5-98.
Here you can view record channel, alarm input/output information, software version, release date,
etc. Please note the following information is for reference only.
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-98
209