Qvis IZEUS 7000 NVR RANGE User Manual page 104


WIFI working status: Here you can view current connection status.
Please note:

After a successful connection, you will see WIFI connection icon at the top right corner of
the preview interface.

When the hotspot verification type is WEP, system displays as AUTO since the device
cannot detect its encryption type.

System does not support verification type WPA and WPA2. The display may become
abnormal for the verification type and encryption type.
After device successfully connected to the WIFI, you can view the hotspot name, IP address,
subnet mask, default gateway, etc. Right now the system support TOTOLINK_N2200UP module.
3G
4.11.1.3
3G setup interface is shown below. See Figure 4-93.
Please refer to the following contents for the parameter information.

Pane 1: Display 3G signal intensity after you enabled 3G function.

Pane 2: Display 3G module configuration information after you enabled 3G function.

Pane 3: Display 3G module status information after you enabled 3G function.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-92
95