Network Test - Qvis IZEUS 7000 NVR RANGE User Manual

Switch
4.11.1.14
This is for you to set IP address, subnet mask, gateway , etc. of the Switch. See Figure 4-108.
4.11.2

Network Test

In this interface, you can see network test and network load information.
Network Test
4.11.2.1
From Main menu->Info-Network->Test, the network test interface is shown in Figure 4-109.

Destination IP: Please input valid IPV4 address and domain name.

Test: Click it to test the connection with the destination IP address. The test results can
display average delay and packet loss rate and you can also view the network status as OK,
bad, no connection , etc.

Network Sniffer backup: Please insert USB2.0 device and click the Refresh button, you can
view the device on the following column. You can use the dropdown list to select peripheral
device. Click Browse button to select the snap path. The steps here are same as preview
backup operation.
You can view all connected network adapter names (including Ethernet, PPPoE, WIFI, and 3G),
you can click the button
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-108
on the right panel to begin Sniffer. Click the grey stop button to stop.
110