Table of Contents
Advertisement
3.
After you connect the PoE, the system follows the principles listed below to map a
channel.
a)
If this is the first time the PoE has been connected, the system can map it to the first
idle channel. After the mapping, the channel can memorize the MAC address of the
IPC. This is a <Channel>---<IPC mac> map. If current channel does not connect to
the other device, system can memorise the current MAC address, otherwise it can
refresh to the newly added device and memorise the <PoE port>---<Channel>.
b)
If This is your second time the PoE has been connected, the system can check the
saved MAC address according to <Channel>---<IPC mac> map to make sure
current IPC has connected correctly or not. If system finds the previous information
and the channel is idle, system can map it to the previously used channel.
Otherwise system goes to the next step.
c)
Thirdly, according to the <PoE port>---<Channel> map, the system may know the
previous mapping channel of current PoE port. System can select the current
channel if This is free. Otherwise, it goes to the next step:
d)
The system goes to find the first idle channel it finds.
Generally speaking, once you connect the PoE, the system will follow the steps listed above to
find the channel available.
System can pop up a dialogue box for you to select a channel to overwrite. The title of the pop-up
interface is the name of the current operational PoE port. In this interface, All PoE channels will
become grey and you will not be able to select them.
© Copyright Qvis ®. All documentation rights reserved.
139
Advertisement
Table of Contents
