5.5 Image/Alarm-out
Select one monitor channel video and then click Image button in section 9, the interface is shown
as Figure 5-10.
5.5.1 Image
Here you can adjust its brightness, contrast, hue and saturation. (Current channel border
becomes green).
Or you can click Reset button to restore system default setup.
Figure 5-10
5.5.2 Alarm output
Here you can enable or disable the alarm signal of the corresponding port. See Figure 5-11.
Figure 5-11
5.6 Zero-channel Encode
Select a window and then click zero-channel encode button, the interface is shown as below. See
Figure 5-12.
© Copyright Qvis ®. All documentation rights reserved.
147