Qvis IZEUS 7000 NVR RANGE User Manual page 48

In the main menu, from Setting->System->PTZ, you can see an interface is shown in Figure
4-26. Here you can set the the following items:

Channel: Select the current camera channel.

PTZ type: There are two types: local/remote. Please select local mode if you are connect
RS485 cable to connect to the Speed dome (PTZ). Please select remote mode if you are
connecting to the network PTZ camera.

Protocol: Select corresponding PTZ protocol(such as PELCOD)

Address: Default address is 1.

Baud rate: Select corresponding baud rate. Default value is 9600.

Data bit: Select corresponding data bits. Default value is 8.

Stop bit: Select corresponding stop bits. Default value is 1.

Parity: There are three options: odd/even/none. Default setup is none.
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 4-27.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-26
39