5.11 Alarm
Click alarm function, you can see an interface is shown as Figure 5-107.
Here you can set device alarm type and alarm sound setup (Please make sure you have enabled
audio function of corresponding alarm events).
Please refer to the following sheet for detailed information:
Type
Parameter
Alarm
Video loss
Type
Motion detection
Tampering
Disk full
Disk error
External alarm
IPC
alarm
IPC offline alarm
Operation Prompt
Alarm
Play
Sound
sound
Sound path
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-107
Function
System alarms when video loss occurs.
System alarms when motion detection alarm
occurs.
System alarms when camera is viciously masking.
System alarms when disk is full.
System alarms when disk error occurs.
Alarm input device sends out alarm.
external
It refers to the on-off signal from the network
camera. It can activate the NVR local activation
operation.
System can generate an alarm when the network
camera and the NVR are disconnected.
Check the box here, system can automatically pops
up an alarm icon on the Alarm button in the main
interface when there is an alarm.
alarm
System sends out alarm sound when an alarm
occurs. You can specify as you wish.
Here you can specify alarm sound file.
216