Qvis IZEUS 7000 NVR RANGE User Manual page 105

This is to display current wireless network signal intensity such as EVDO, CDMA1x, WCDMA,
WCDMA, EDGE , etc.

3G module: This is to display current wireless network adapter name.

3G Enable/Disable: Check the box here to enable 3G module.

Network type: There are various network types for different 3G network modules. You
can select according to your requirements.

APN: This is the wireless connection server. This is to set you access the wireless
network via which method.

AUTH: This is the authentication mode. It supports PAP/CHAP.

Dial number: Please input 3G network dialup number you got from your ISP.

User name: This is the user name for you to login the 3G network.

Password: This is the password for you to login the 3G network.

Pulse interval: You can set the dialup duration. Once you disable the extra stream, the
connection time begins. For example, if you input 5 seconds here, then 3G network
connection period is 5 seconds. The device automatically disconnect when time is up. If
there is no extra stream, 3G network connection is valid all the time. If the alive time is 0,
then the 3G network connection is valid all the time.

Dial: Here you can enable or disable 3G network connection/disconnection manually.

3G wireless network: Here is to display wireless network status, SIM card status, dial
status. If the 3G connection is OK, then you can see the device IP address the wireless
network automatically allocates.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-93
1
2
3
96