Figure 4-15
4.4.6 UPNP
Important
Do not connect the switch to the PoE port, otherwise the connection may fail!
Please connect the IPC to the PoE port of the device rear panel (Figure 4-16), system can auto
connect to the network camera. Please note the following figure is for reference only.
Figure 4-16
4.4.7 Built-in Switch Setup
From Main menu->Setting->Network->Switch, you can set the switch IP address, subnet mask,
gateway , etc.. See Figure 4-17.
© Copyright Qvis ®. All documentation rights reserved.
30