Qvis IZEUS 7000 NVR RANGE User Manual page 180

5.8.2.12 Auto Register
The auto register interface is shown as below. See Figure 5-36.
This function allows the device to auto register to the proxy you specified. In this way, you can use
the client-end to access the NVR, etc. via the proxy. Here the proxy has a switch function. In the
network service, device supports the server address of IPv4 or domain.
Please follow the steps listed below to use this function.
Please set proxy server address, port, and sub-device name at the device-end. Please enable the
auto register function, the device can auto register to the proxy server.
5.8.2.13 Alarm Centre
The alarm center interface is shown as below. See Figure 5-37.
This interface is reserved for you to develop. System can upload alarm signal to the alarm center
when local alarm occurs.
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-35
Figure 5-36
171