Detect; Motion Detect - Qvis iBox nvr User Manual

Detect

5.6.7
Go to Detect Menu
In the main menu, select 'Setting' and then 'Detect', you will see the motion detect interface.
See Figure 5-59. There are three detection types: motion detection, video loss, camera
masking.

The video loss has no detection region and sensitivity setup. Camera masking has no
detection region setup.

You will see the motion detect icon if the current channel has the motion detect alarm
enabled.

You can drag your mouse to setup the motion detect region without using the Fn button.
Please click the 'Save' button to save current region setup. Right click mouse to exit
current interface.

5.6.7.1 Motion Detect

Detection menu is shown above. See Figure 5-59.

Event type: From the dropdown list you can select motion detection type.

Channel: Select a channel from the dropdown list to set motion detect function.

Enable: Check the box here to enable the motion detect function.

Region: Click select button, the interface is shown as in Figure 5-60.
motion detection zone. There are 396(PAL)/330(NTSC) small zones. The green is the current
cursor position. White is the motion detection zone. Red is the disarmed zone. You can click
© Copyright Qvis ®. All documentation rights reserved.
Figure 5-59
Here you can set
64