Qvis IZEUS 7000 NVR RANGE User Manual page 87

system detects the local alarm again. The screen prompt, alarm upload, email , etc. will not be
activated. For example, if you set the anti-dither time as 10 second, you can see the each
activation may last 10s if the local alarm is activated. During the process, if system detects
another local alarm signal at the fifth second, the buzzer, tour, PTZ
record channel will begin another 10 seconds while the screen prompt, alarm upload, email
will not be activated again. After 10 seconds, if system detects another alarm signal, it can
generate an alarm since the anti-dither time is out.
7. Period: Click the set button, you will see an interface is shown in Figure 4-74. Here you can
set the motion detect period. System only enables motion detect operation in the specified
periods. This is not for video loss or the tampering. There are two ways for you to set periods.
Please note system only supports 6 periods in one day.
In Figure 4-74, Select icon
Now the icon is shown
In Figure 4-74. Click button
in Figure 4-75. There are four record types: regular, motion detection (MD), Alarm, MD &
alarm.
8. Alarm output: when an alarm occurs, system enables peripheral alarm devices.
9. Latch: when motion detection complete, system auto delays detecting for a specified time.
The value ranges from 1-300(Unit: second)
10. Show message: System can pop up a message to alarm you in the local host screen if you
enabled this function.
11. Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.
12. Send email: System can send out email to alert you when an alarm occurs.
13. Record channel: System auto activates motion detection channel(s) to record once an alarm
occurs. Please make sure you have set MD record in Schedule interface(Main
Menu->Setting->Schedule) and schedule record in manual record interface(Main
Menu->Advanced->Manual Record)
14. PTZ activation: Here you can set the PTZ movement when an alarm occurs. Such as go to
preset, tour &pattern when there is an alarm. Click "select" button, you can see an interface is
shown in Figure 4-73
15. Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
16. Tour: Here you can enable tour function when alarm occurs. System one-window tour.
17. Snapshot: You can enable this function to snapshoot image when a motion detect alarm
occurs.
18. Video matrix: Check the box here to enable this function. When an alarm occurs, SPOT OUT
port displays device video output. It displays video (1-window tour) from alarm activation
channel you select at the Record channel item.
19. Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Please highlight icon
click save button, system goes back to the previous menu.
© Copyright Qvis ®. All documentation rights reserved.
of several dates, all checked items can be edited together.
. Click to delete a record type from one period.
after one date or a holiday, you can see an interface shown
.
X
to select the corresponding function. After all the setups please
activation, snapshot,
78