Preview Parameter - Qvis IZEUS 7000 NVR RANGE User Manual

Now you can set the corresponding information.

Transparency: This is for you to adjust transparency. The value ranges from 128 to 255.

Channel name: This is for you to modify channel name. System max support 25-digit (The
value may vary due to different series). Please note all your modification here only applies to
NVR local end. You need to open web or client end to refresh channel name.

Time display: You can select to display time or not when system is playback.

Channel display: You can select to channel name or not when system is playback.

Resolution: There are four options: 1280×1024 (Default), 1280×720, 1920×1080, 1024×768.
Please note the system needs to reboot to activate current setup.

Image enhance: Check the box; you can optimise the margin of the preview video.
Click OK button to save current setup.
Note
The display parameter here has no effect on the record file and playback effect.

4.5.5 Preview Parameter

Set preview display mode, channel display sequence and tour setup.

Set preview display mode: On the preview interface, right click mouse, you can view
right-click menu. Now you can select preview window amount and channel.

Set channel display mode: On the preview interface, if you want to change channel 1 and
channel 16 position, please right click channel 1 video window and then drag to the channel
16 video window, release button, you can change channel 1 and channel 16 position.

Tour setup: Here you can set the preview window channel display mode and interval. Please
follow the steps listed below.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-24
37