From Main menu->Setting->System->Display, you can see an interface shown in Figure 4-25.
Here you can set the tour parameter.
Enable tour: Check the box here to enable tour function.
Interval: Input proper interval value here. The value ranges from 1-120 seconds.
Monitor tour type: System support 1/8-window tour.
Alarm tour type: System support 1/8-window tour.
Tips
On the navigation bar, click
setup.
4.6 PTZ
Note:
Before you control the PTZ, please make sure the PTZ decoder and the NVR network
connection is OK and the corresponding settings are right.
4.6.1 PTZ Settings
Cable Connection
Please follow the procedures below to go on cable connection:
1.
Connect the dome RS485 port to NVR RS485 port.
2.
Connect dome video output cable to NVR video input port.
3.
Connect power adapter to the dome.
© Copyright Qvis ®. All documentation rights reserved.
Figure 4-25
/
to enable/disable tour. Click Save button to save current
38