Lcd Message Troubleshooting Table - Printronix P8000 Series Administrator's Manual

Table 1. LCD Message Troubleshooting Table (ASCII)
Displayed Message
TCB CORRUPTED*
TCP PORT BUSY
UP DRV. SHORT*
UPGRADED - REMOVE SPX
Downld code if needed
WELD NOT DETECT
See User Manual
WELD SNSR ERROR
See User Manual
WELD SNSR MISSING
See User Manual
XXXX
CHECKING PATTERN
XXXX
MEMORY FAILURE
XXXX
WRITING PATTERN
1
Before contacting an authorized service representative, power off the printer, wait 15 seconds, then
power it back on and rerun your print job. If the message reappears, press CLEAR. If the fault message
still displays, then contact your authorized service representative.
Fault Messages (H-Series with Numerical Prefix)
Can User
Explanation
Correct?
No Task Control Block
Corrupted. Firmware
error on controller board.
Yes Error message reported
by the Printer Manager
when ethernet interface
option is installed. The
network address given in
the printer properties was
reached, but the printer
port is busy.
No Upper Driver Short.
Hammer driver circuits on
the boards shorted to
ground.
No Status message: An SPX
has successfully
upgraded the
security key on the
controller board.
No The cartridge weld was
not detected.
No The cartridge sensor
could not be calibrated.
Yes The incorrect cartridge
type is being used for the
printer.
No Running power on
memory test.
No Memory in bank xxx has
failed. Power on memory
test.
No Running power on
memory test.
Printing a Hex Dump
Solution
Contact your authorized
1
service representative.
Refer to the Printronix P8000
Maintenance Manual.
Cycle power to see if the
message clears, if not, contact
your authorized service
1
representative.
Remove SPX and download
code if needed.
Contact your authorized
1
service representative.
1. Make sure your cartridge
is properly seated.
2.
Contact your authorized
service representative.
1. Make sure the correct
ribbon cartridge type is
installed.
2.
Make sure the cartridge is
properly seated.
3.
Contact your authorized
service representative.
No action is required.
Contact your authorized
1
service representative.
No action is required.
1
1
315