Lcd Message Troubleshooting Table - Printronix P7000 User Manual

Table 13. LCD Message Troubleshooting Table
Displayed Message
UNDFNED OPCODE* No
UNKNOWN RBN1 Yes
Install New RBN
UP DRV. SHORT* No
WAITING FOR N/A
ETHERNET ADAPTER
WELD NOT DETECT No
See User Manual
WELD RESET ERROR No
See User Manual
WELD SNSR MISSING Yes
See User Manual
1
Before contacting an authorized service representative, power off the printer, wait 15 seconds, then
power it back on and rerun your print job. If the message reappears, press CLEAR. If the fault message still
displays, then contact your authorized service representative.
Can User
Explanation
Correct?
Undefined Opcode.
Firmware error on
controller board.
The sensor detects a bar
code, but the ribbon
model is not permitted on
this printer.
Upper Driver Short.
Hammer driver circuits on
the boards shorted to
ground.
Status message: Appears
when the printer is first
powered on if the optional
Network Interface Card is
installed.
The cartridge weld was
not detected.
The cartridge weld
circuitry lost power.
The incorrect cartridge
type is being used for the
printer.
Fault Messages
Solution
Contact your authorized service
1
representative.
Install a new ribbon.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
1. Make sure that the correct
ribbon cartridge type is
installed in the printer.
2.
Contact your authorized
service representative.
1
1
287