Printronix P8000 Series Administrator's Manual page 308

Chapter 8
Fault Messages (ASCII in Alphabetical Order)
Table 1. LCD Message Troubleshooting Table (ASCII)
Displayed Message
LOADING PROGRAM
FROM PORT XX%
LOADING PROGRAM INTO
FLASH
NEW SPX DETECTED
PRESS ENTER
NON VOLATILE MEMORY
FAILED
ONLINE
PANEL
BAD CHECKSUM
PAP BAD TABLE*
PAP FD DRVR CIR*
See Manual
PAP FIFO OVERFL*
PAP FIFO UNDRFL*
308
Can User
Explanation
Correct?
No Status message: the new
emulation program is
loading into printer RAM.
XX% indicates how much
of the program has
loaded.
No The printer has deleted
the previous program
from flash memory and is
loading the new program
into flash memory.
No The printer detects an
SPX installed at the
debug port and the SPX
is valid for the printer.
No Large emulations reduce
the amount of space
available for saving
configurations, which
means that sometimes
fewer than eight
configurations can be
saved.
N/A Printer state message:
printer is online and in
communication with host.
No Panel Code has a bad
Checksum.
No Paper Bad Table. The
paper feed process on
the controller board has a
corrupted table.
No Paper Feed Driver
Circuit. The paper feed
driver circuit on the
controller board is
drawing too much
current.
No Paper First In First Out
Overflow. Firmware error
on controller board.
No Paper First In First Out
Underflow. Firmware
error on controller board.
Solution
No action is required.
No action is required.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
No action is required.
Reload released firmware.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.
Contact your authorized
1
service representative.