Position The Paper Out Sensor - Printronix P8000 Series Administrator's Manual

Appendix D
Operation

Position the Paper Out Sensor

Sensor Knob
Paper
The paper out sensor indicates when the printer runs out of paper. (The
sensor does not work with black backed forms.) Unlike the standard pedestal
printer, the ZT printer requires you to load the paper through the paper out
sensor slot (Figure 3 and Figure 6). Correct positioning of the paper out
sensor ensures that the last form the printer prints will be properly presented
to the tear bar. To position the paper out sensor, do the following:
1. Position the paper properly at the tear bar (page 356).
2. Loosen the paper out sensor by turning the sensor knob
counterclockwise.
3. Position the paper out sensor so that there are at least 2 inches between
the bottom of the aluminum extrusion bar and the top of the paper out
sensor.
IMPORTANT
For optimal performance, 2 inches is recommended for 11 inch forms.
For shorter forms, position the paper out sensor so that there are at
least 2 inches between a perforation and the top of the paper out sensor.
4. Tighten the paper out sensor by turning the sensor knobs clockwise.
5. Press ONLINE. When the first print job is sent to the printer, the paper is
drawn into the printer, the top of form aligns with the print station, and the
print job begins.
354
At least 2 inches
Figure 6. The Paper Out Sensor
Paper Out Sensor