Line Matrix Commands - Printronix P8000 Series Administrator's Manual

Three things can limit the ability to save a file: insufficient RAM, insufficient
Flash, and lack of empty file system entries. Flash can only be written once
before it needs to be "optimized". As a result, the maximum file size is limited
to the largest unwritten block of Flash. If any of these problems occur, the
printer will display an error message and will attempt to provide the operator
with a description of what steps to take to correct the error. Normally, the
solution will involve optimizing the Flash File System. This can be
accomplished by selecting the Optimize & Reboot function in the Flash File
System menu under the ADVANCED USER menu, "Main File System."
NOTE: After selecting the Optimize & Reboot function, do not shut off the

Line Matrix Commands

Table 2 lists PTX_SETUP commands which apply to line matrix printers only.
Table 2. Line Matrix PTX_SETUP Commands
Command Sub-Command
ENGINE EJECT
printer's power until after the printer returns to the power-on state.
Loss of power during the optimize process may corrupt the printer's
program. If this occurs, first attempt to repeat the downloading
process. If that fails, contact an authorized service representative.
Parameter
Line Matrix Commands
Description
Performs a page eject.
377