Printronix P8000 Series Administrator's Manual page 330

Chapter 8
Fault Messages (H-Series with Numerical Prefix)
Table 2. LCD Message Troubleshooting Table (H-Series)
Can User
Displayed Message
LOADING PROGRAM No
INTO FLASH
NEW SPX DETECTED No
PRESS ENTER
NON VOLATILE No
MEMORY FAILED
ONLINE N/A
PANEL No
BAD CHECKSUM
PARAMETER ERROR* No
PLAT DRVR CIR No
PLEASE WAIT... N/A
RESET IN
PROGRESS
PRINTER UNDER No
REMOTE CONTROL
PROCESSOR No
HALTED
EC_FAULT_RTSYS2
REMOVE USED SPX No
THEN PRESS ENTER
RESTORING BOOT No
CODE
330
Explanation
Correct?
The printer has deleted the
previous program from flash
memory and is loading the
new program into flash
memory.
The printer detects an SPX
installed at the debug port
and the SPX is valid for the
printer.
Large emulations reduce the
amount of space available
for saving configurations,
which means that
sometimes fewer than eight
configurations can be saved.
Printer state message:
printer is online and in
communication with host.
Panel Code has a bad
Checksum.
Illegal parameter value
received in command code
over a TN emulation.
Platen driver circuit
malfunction.
Status message: the printer
finished loading the program
into flash memory and is
automatically resetting itself.
Status message: The printer
is under the control of
PrintNet Enterprise (PNE)
remote management
software.
Real-time System Firmware
error on controller board.
Status message: An SPX is
depleted because it has
successfully reprogrammed
the security key on the
controller board.
Normal download
initialization message.
Solution
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required.
Reload released firmware.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required.
No action is required.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
No action is required.