Printronix P8000 Series Administrator's Manual page 117

FF Validity
Determines if the position of a form feed command affects its execution.
•
Off (factory default). Performs a form feed only if it occurs at the first print
position in a line or at Maximum Print Position +1. A form feed command
at any other position is recognized as a space.
•
On. Allows the printer to perform a form feed command anywhere in the
data stream.
Auto Skip At End
Specifies whether or not to perform an automatic form feed at the end of a
print buffer. If form feed is the last character in the print order, the form feed
function is supplied by the Auto Skip At End option.
•
Off (factory default). Sets the printer to print at print position 1 of the next
line.
•
On. Sets the printer to print at print position 1 of the first line of the next
form.
FF After Job
Determines the print position after an operator-initiated local copy (print
screen function).
•
Off (factory default). Performs an automatic new line command after
completing a print buffer (unless a new line, form feed, or carriage return
command was the last one executed). The printer is set to print at print
position 1 of the next line.
•
On. Performs an automatic form feed command unless a form feed was
the last one executed. The printer is set to print at print position 1 of the
first line on the next form.
CR, EM, and NL (3287 only)
CR (Carriage Return), EM (Error Message), and NL (New Line) specify that
the printer treat the CR, EM, and NL control codes either as spaces or as
control codes.
•
On (factory default). Treats the CR, EM, and NL commands as control
codes.
•
Off. Treats the CR, EM, and NL commands as spaces.
3270 Params
117