Printronix P8000 Series Administrator's Manual page 142

Chapter 4
EMULATION Menu
DBCS Compressed (H-Series)
This parameter allows you to specify the appearance of ASCII/DBCS
characters in DBCS mode. It is not applicable for the H-Series Hangul printer.
•
Disable (factory default)
•
Enable. Both the DBCS and ASCII characters will be printed as half-width
of their original size.
Font Scale (H-Series)
This parameter allows you to specify the appearance of the font size. It is
applicable for the H-Series GB printer.
•
Standard (factory default). The character prints as 24 x 24 cell size.
•
16 x 24. The character prints as 16 x 24 cell size.
Encoding (H-Series)
•
Address Table (factory default). Specifies the address table supported.
•
UTF-8. The printer takes in UTF-8 data stream and prints out according to
Unicode format.
Taller 15 CPI (H-Series)
This parameter allows you to specify the appearance of ASCII characters as
15 CPI in ASCII mode.
•
Disable (factory default). The characters in 15 CPI appear shorter than
other CPIs such as 10 CPI.
•
Enable. The height of 15 CPI characters is the same as other CPIs such
as 10 CPI.
Horizontal Expnd (H-Series)
This parameter allows you to specify dot character horizontal expansion for
both ASCII and DBCS characters in DBCS mode.
Vertical Expnd (H-Series)
This parameter allows you to specify dot character vertical expansion for both
ASCII and DBCS characters in DBCS mode.
142
GB18030 is for Hanzi GB printer.
BIG5 (factory default), CNS, TCA, ETEN, IBM5550, TELETEXT,
BIG5+, BIG5E, and HKSCS are for Hanzi Big5 printer.
KSC5601 is for Hangul printer.
Shift-JIS is for Kanji printer.