Printronix P8000 Series Administrator's Manual page 372

Cartridge ribbon printer

Hide thumbs Also See for P8000 Series:

Table of Contents

The PTX_SETUP Commands

Table 1. PTX_SETUP Commands (Non-Platform Specific) (continued)

This command overlays the

configuration data that follows on

existing configuration Cfg. Cfg must

be 1-8 (or END). If Cfg does not

exist then command is treated the

same as DOWNLOAD.

Reboots the printer.

This command uploads the names

of the configurations to the port

specified by Port. Port must either

be "1284" or "SERIAL".

This command downloads a name

for the configuration specified by

Cfg. Cfg must be 1-8.

This command resets all of the

configuration names to their default

This command selects the active

Management Protocol Interface

(MPI). Currently there are two

selections "UCP" and "PXML".

This command selects the port that

the PNE will use to communicate to

the printer.

The valid ports are:

NOTE: If ETHERNET is selected

but not enabled, the

selection will revert to

Troubleshooting