Mounting The Cp180 Or The Cp300 External Gps Antenna - Standard Horizon CP180 Owner's Manual

1. After a location is found, peel the template label from the backing and apply the label
to the mounting area.
2. Drill a hole in one area of the cutout area that will allow the blade of a jig saw to be
inserted. Insert and cut out the area on the panel using the jig saw.
3. Next drill the four holes required to insert the GPS Chart Plotter with the mounting studs.
4. Install the mounting studs on the GPS Chart Plotter and insert into the mounting hole.
5. Attach the GPS Chart Plotter to the mounting location by attaching the supplied
hardware to the mounting studs.
M4 threaded
2.3 MOUNTING THE CP180 OR THE CP300 EXTERNAL GPS
ANTENNA
The CP180 and CP300 are supplied with an external WAAS GPS antenna with 15 meter
of routing cable. This antenna is designed to be mounted on a base, installed on an
extension or even flush mounted.
Choose a location for the antenna that has a clear view of the sky and is not located within
GPS Chart Plotters
Figure 2.2a - Example of CP300 Flush installation
4 mm 20 mm
27 mm
Figure 2.2b - Mounting Screws
M4 threaded
Page 15