Ricoh FT5540 Service Manual page 376

31 August 1989
7. Loosen the front wire tightener [A] (1 screw).
8. Remove the right lift rod [B] from the braces [C] (front side first).
9. Disengage the front end of the left lift rod [D] by raising it partway; then, lift it out from the
top.
10. Remove the inner cover [E] (2 short and 2 long screws).
11. Replace the tray down sensor [F] (1 screw and 1 connector).
12. Rotate the paper size dial to select a smaller paper size such as A4R, and remove the
positioning switch bracket [G] (1 screw).
13. Replace the positioning switch [H] (2 screws).
NOTE: When reassembling, make sure that the ends with the holes [I] are at front.
10-16