Scanner Harness Replacement (Optics Cables & Exposure Lamp) - Ricoh FT5540 Service Manual

31 August 1989
1.6 Scanner Harness Replacement (Optics Cables & Exposure Lamp)
1. Remove the rear and left covers (2 screws each). Then, remove the exposure glass.
(Refer to "Exposure Glass Removal.")
2. Open the front cover, and remove the left inner cover. Then, disconnect the exposure
lamp connector [A] (white 2P connector), and push the female half of the connector [B]
through the frame into the optics cavity.
3. Remove the front and rear lamp terminal covers [C] (1 screw each). Then, remove the
reflector cover [D] (2 screws).
NOTE: Do not touch the surface of the reflector.
4. Disconnect the front and rear lamp terminals [E]. Then, remove the auto ID sensor with the
bracket [F] (1 screw).
5-10