Ricoh FT5540 Service Manual page 351

31 August 1989
11. Secure the sorter ground wire [A] (1 screw). (A toothed washer [B] must also be installed
with the European version).
12. Connect the three connectors as follows:
Red 2P [C] to Red 2P free
White 4P [D] to white 4P free
White 12P [E] to CN108 on the main PCB
13. Reinstall the main PCB (2 screws).
14. Install the sorter covers and copier rear cover.
15. Peel off the cover [F] from the Sort/Stack key panel (left side of the operation panel).
16. Install the Sort/Stack key top [G] (copier accessory), and affix the Sort/Stack key cover [H]
(copier accessory) as shown.
17. Set SP71-1 to enable the sorter. (Refer to the copier installation procedure.)
18. Check the sorter's operation and fill out the New Equipment Condition Report.
9-14